SINGLE REAR MOUNTED ASSEMBLIES

About Single Rear Mounted Assemblies

Single Rear Mounted Assemblies are ideal for use on wider spacings or when full independence of each wheel is required. This type of assembly is a simple and cost effective way of attaching press wheels to the rear of a machine. When using these assemblies on narrow spacings, we recommend fitting heavy duty overcaps to the wheels or staggering the press wheels.

Available in: High mount or low mount

Download brochure here

Advantages

gray-tick   Will track accurately over the seed bed, including during turns

gray-tick   Consistent pressure

gray-tick   Easy to adjust

gray-tick   Easy access for maintenance

gray-tick   Good Trash management

gray-tick   Good Mud Management

gray-tick   Good ground clearance

gray-tick   Can be used with both 15” and 18” wheels.

gray-tick   Can be easily fitted with seed tubes (a range of seed tubes is available)

Single Swivel Rear Mount

  • Fitted by fitting a 3” or 4”toolbar across the rear of the machine
  • The toolbar can either be fixed (welded in place) or detachable
  • Single high rear mount assembly are supplied with UBolts
  • To assist with trash flow, fit in a staggered assembly

BUY ONLINE

Single Swivel Low Mount

  • Fitted by  fitting a new 3” RHS toolbar across the rear of the machine
  • The toolbar can either be fixed (welded in place) or detachable
  • Single low rear mount assemblies are light weight
  • They do not extend too far back from rear machine

BUY ONLINE